Plein Air PI-3500 Mode D'emploi page 18

9. Child Lock
a) Press "Max Power / Temperature Shortcut Button" and "Min Power / Temperature Shortcut Button" at
the same time for 2 seconds, the cooker enters into lock function. During this mode, it will lock the control
panel except "On/Off Button" and lock button (keep pressing "Max Power / Temperature Shortcut Button"
and "Min Power / Temperature Shortcut Button" at the same time for 2 seconds), the LED display screen
shows "Loc".
b) In the mode of lock, the LED display screen shows power/temperature and "Loc" alternately.
c) In the mode of lock and timer, the LED display screen shows power/temperature, remaining timer and
"Loc" alternately.
d) In the mode of lock, press "On/Off Button" to turn off the cooker, the "Lock LED" will keep consistent
on, the LED display screen shows "Loc". Keep pressing "Max Power / Temperature Shortcut Button" and
"Min Power / Temperature Shortcut Button" at the same time for 2 seconds again to unlock the panel and
then you could turn on the cooker.
e) In the mode of lock, keep pressing "Max Power / Temperature Shortcut Button" and "Min Power /
Temperature Shortcut Button" at the same time for 2 seconds again, "Lock LED" goes out, the control
panel is unlocked.
10. Fan Keeps Working
a) The fan will keep working for 2 minutes to 5 minutes for heat dissipation after finish cooking. It will stop
automatically until the glass surface temperature below 50°C.
11. High Temperature Indicator
a) After turn off, the LED display screen shows "H" (High Temperature Indicator), it will disappear only
after the glass surface temperature below 50°C.
12. Automatically Switch Off When No Operation for 2 Hours
a) In working mode, the cooker will automatically switch off if without any operation after 2 hours except
the mode of timer.
MAINTENANCE
1. Turn off the appliance by pressing button "On/Off" and wait until the light turns off. Once off, unplug the
power cord properly.
2. Wait for some time and let the appliance cool down.
3. You can use mild detergent or dishwashing liquid with a soft cloth to remove dirt.
4. Do not clean it with running water or immerse it in water as water will get inside and damage the appliance.
5. Always make sure that the top plate and the pan/pot is clean before cooking as the dirt from the pan/pot will
stick to the plate and plate will get discolored.
6. You may clean the air vent by vacuum cleaner to suck up the dirt or you can use cotton if the dirt is with oil.
7. Toothbrush with little soap can also be used to clean the surface as long as you use it gently on the appliance.
8. Do not use abrasives or strong detergents as it may get chemical reaction.
9. After dirt has been removed, use a dry, soft cloth to wipe dry the appliance.
TROUBLE
Power indicator not on
Power off automatically
LED shows E0
LED shows E2
LED shows E3
DT Istr (PI-3500) 10/17_Rev. 1
TROUBLE SHOOTING
POTENTIAL CAUSES
Power cord is not connected well
1. Spare parts over heat
2. No operation in two hours
1. No pot
2. Pot too small
Temperature sensor open circuit or
short circuit
High voltage protection
RESOLUTION
Please ensure the plug inserted into
the socket
Please restart the cooker, otherwise,
return it to the service center for
checking and repairing
Put the suitable pot on the surface of
the cooker. It will return to the state of
power on if without any operation for
30 seconds.
Please return the cooker to the service
center for checking and repairing
Please ensure 150V<voltage<270V.
PI-3500
18/25