Publicité
OPERATION
POST-OPERATION
1. Turn the power switch to "OFF". The unit will
power down and the red light inside the power
switch will stop illuminating.
2. Switch the unit off at the mains power switch.
3. Allow the unit to cool down (approximately 30
minutes after power down).
4. Remove the power cable and remote control from
the unit.
5. Loosen the fluid reservoir cap and remove the
hose from the reservoir.
6. Empty the fluid reservoir of any remaining fluid,
being careful not to spill any liquid on or around
the unit.
7. Reinsert the hose into the fluid reservoir and hand
tighten the cap.
8. Wipe off any excess liquid on the unit with a dry,
lint free cloth.
SERVICING
Clean the fog machine regularly to avoid problems.
Making sure the cap is tightly sealed during use will
also keep the machine in good condition.
After approximately 40 hours continual use, the
reservoir and hose should be cleaned thoroughly.
1. Ensure that "POST OPERATION" checklist has
been conducted before beginning servicing.
2. Remove all remaining fog fluid from the fluid
reservoir, being careful not to spill any liquid on
or around the unit.
3. Create a mixture of 80% distilled water and 20%
white vinegar and add to the fog machine.
4. Follow PRE-OPERATION, OPERATION and
POST-OPERATION check-lists, indicated above.
Approximately 10 long sprays should remove any
unwanted dirt from the internal components of
the unit.
13
Publicité
