Télécharger Imprimer la page

Gear4music FOG-400A Mode D'emploi page 12

Publicité

OPERATION
INSTALLATION
1. Remove all packing material, taking special care
to ensure the nozzle is free of packaging.
2. Place the unit on a level surface and loosen the
cap of the fluid tank.
3. Add high quality water-based fog liquid in the
machine and screw the cap of the fluid tank.
Lower quality fog liquid will damage fog machine.
4. Plug the remote control into the socket on the
rear side.
5. Plug the unit into mains power.
OPERATION
1. Turn the switch to "ON" and the machine will heat
up. When the unit has reached the operating
temperature the green LED on the remote control
will light up.
2. Press the button, the machine will spray fog.
Release the button when the desired amount of
fog has been produced.
3. After long bursts it is normal that the unit shuts
down itself for a short period in order to reach
operating temperature again. The green LED on
the remote control will go off during this period.
Wait until the green LED lights up again to spray
fog.
4. Check frequently whether there is enough fog
liquid in the machine. Using the unit without fog
liquid may damage the machine.
5. If the fog output is low, the unit makes an unusual
noise or there is no fog output at all, please power
off and check fog liquid, fuse and power plug. If
the problem hasn't been solved after checking
these parts, contact Gear4music.
SERVICING
• Clean the fog machine regularly to avoid
problems. Making sure the cap is tightly sealed
during use will also keep the machine in good
condition. After about 40 hours of continual use,
please use 80% distilled water and 20% vinegar
to remove the dirt in the nozzle. Let the unit cool
down. Disassemble the nozzle and use vinegar
and a pipe cleaner to clean it.
• Make sure that the unit is always unobstructed
during use.
• To clean the unit thoroughly empty the tank and
fill with cleaning fluid. Plug the unit into a wall
outlet and heat up as usual. Run it in a well-
ventilated place until the tank is empty.
• Replace the nozzle. Unplug the unit and fill it with
normal fog fluid.
12

Publicité

loading