Gtec MULTI ATF047 Manuel D'utilisation page 36

Power brush
Remove the standard nozzle by pulling
gently on the green locking ring until the
nozzle comes free from the Multi. The
power must be off while changing nozzles.
To clean the brush bar, first remove the
brush tool. Rotate the latch from the lock
to the unlock position and pull out the
brush bar.
36
To attach the power brush slot it into place
until the locking ring clicks back. The power
button will now power the brush as well as
the suction.
To remove hair from the brush bar, run an
open pair of scissors down the groove to
cut the hair, then pull it out. Never operate
the power head without the brush bar in.