Publicité
Les langues disponibles
Les langues disponibles
9198789
ASSEMBLY & INSTALLATION
Letter references in parenthesis (A) refer to the included Identification Key.
1.
Peel one side of the double-sided tape (F) from the paper.
2.
Press the tape against the bottom of the GPS speedometer unit.
3.
Clean a spot on the inner windshield where you wish to apply the
reflective film. Allow the spot to dry.
4.
Peel the cover film from side 1 of the reflective film (E).
5.
Flex the reflective film and apply one edge to the windshield. Slowly
press the film against the windshield to avoid air pockets.
6.
Remove the cover film from side 2 of the reflective film.
7.
Plug the OBD connector (L) into your OBD-II port. Arrange the cable so
it is out of the way. You may need to use cable ties (not included).
8.
Plug the USB Mini-B cable connector to the USB port on the GPS
speedometer (see Fig. 2).
9.
Press the power switch (Q) for 5 seconds to turn on the LED projection (B).
10. Adjust the unit' s position until the projected image appears on the
reflective tape.
11.
Once a final position is found, tilt the unit forward and remove the
paper from the double-sided tape. Tilt the unit back into position and
press the unit down to adhere the unit to the dashboard.
12. Turn off the unit until you are ready to change the settings.
OPERATION
MENU SETTINGS
1.
Press and hold the Mode button (M) to enter the menu.
2.
The number 1 is displayed. To change the menu option, press and hold
the parameter plus button (P) to increase the menu number by 1 or
press and hold the parameter minus button (O) to decrease the menu
number by 1.
3.
Press the plus button to enter the selected menu parameter.
4.
Adjust the number with the plus or minus button, based on the menu
options in the tables.
5.
Press the Mode button to exit back to the menu.
6
GPS Speedometer
For technical questions call 1-800-665-8685
V1.0
Publicité
