Publicité
Les langues disponibles
Les langues disponibles
ERRORS
Error codes
P1
P2
*
*
*
*
*
*
*
*
*
*
*
*
EN 22
1/2
3h
6h
interference type
*
*
Insufficient water
supply
*
Pressure system
failure
*
*
Flooding safety
enabled
*
*
*
The dishwasher is
not pumping out
*
*
*
Heating error
*
*
Flooding sound
signal activated
*
*
Interference in the
electronics
*
*
Temperature in the
machine is too high
*
*
Interference of
heating sensor
*
High voltage failure
*
*
Low voltage failure
Should the appliance become overfilled or exhibit excessive
leaking, shut off the inlet tap and alert the service department.
solution
• Make sure that the water faucet is completely
open and that there is no crack in the supply
hose
• Check if the supply hose is clogged
• Restart the dishwasher
• Please contact the service department if the
problem persists
• Please contact the service department
• Close the water faucet and contact the service
department
• Check if the drainage hose is connected
• Check the bottom filter and filter group
• Restart the dishwasher and terminate the last
selected program
• Please contact the service department if the
problem persists
• Please contact the service department
• Turn off the dishwasher and close the water
faucet
• Please contact the service department
• Please contact the service department
• Please contact the service department
• Please contact the service department
• Please contact the service department
• Please contact the service department
Publicité
