Télécharger Imprimer la page

ETNA VW149M/E01 Mode D'emploi page 11

Publicité

Les langues disponibles

Les langues disponibles

OPERATION
Switching on
1. Open the door of the dishwasher.
2. Press the 'on-off' button to switch on the device.
The check light End Program is on.
3. Select the desired program (see 'program selection table').
Select a cycle using the programming button.
The check light that is part of the selected program is on.
4. Close the door of the dishwasher.
The dishwasher will automatically start running the selected cycle.
Half load
Press the Half Load button to reduce the duration of the selected
program and therefore decrease your energy and water consumption.
When Half Load option is selected, the half load indicator lights up.
Delayed start time
If you want the dishwasher to switch on at a later time, you can use the
'delayed start' button. You can choose between a delay time of 3, 6 or
9 hours. Each press of the button changes the delay time.
The indicator of the selected delay time is on.
Then select the desired program and close the door of the dishwasher.
Indicators
• Salt.
The indicator shows that you have to fill the salt container with
regeneration salt.
• Rinse aid.
The indicator shows that you have to fill the rinse aid reservoir.
• End program.
The indicator shows that the washing program has finished.
In addition, you will hear a sound signal five times.
Changing a wash cycle
1. Open the door.
2. Press the program button to select a new program.
The check light that is part of the selected program is on.
3. Close the door of the dishwasher.
The dishwasher will automatically start running the selected cycle.
EN 7

Publicité

loading

Ce manuel est également adapté pour:

Vw149mVw149m/e03Vw149m/e02737276/01737276/02737276/03