Top Panel - ION Digital LP Guide D'utilisation Rapide

Top Panel

1. Platter: Place your record here.
2. Tonearm: The fixed tonearm can be raised
and lowered by hand, or by pressing the
raise / lower lever.
3. Arm Clip: This arm clip secures the
tonearm while at rest or when not in use.
The arm clip has been designed to remain
in the up position while unlocked.
4. 33 / 45 / 78 Switch: This switch controls
the speed of the turntable platter.
Note: For best results when playing 78
RPM vinyl records, use a 78 RPM stylus
(sold separately). Only use a 78 RPM stylus
with 78 RPM vinyl records.
5. Autostop switch: This switch turns autostop
on or off. When autostop is on, the platter will
start spinning when the tonearm is placed over
the record and stop spinning when the record
has reached the end. (When Autostop is off,
the platter will always spin regardless of the
position of the tonearm.)
Note: If your vinyl record stops before it
reaches the end of the music, turn Autostop to
the off position for this particular record. This is
generally recommended for 45 RPM records.
1
IMPORTANT: Place the included felt
slipmat on the platter; then place your
record on the felt slipmat to carefully hold
your records.
IMPORTANT: Remove
cartridge cover (needle cover) before
operating the turntable.
*WARNING: The RCA outputs are LINE
level. Please only connect these to LINE
level inputs. You may damage your
receiver if you plug in a LINE level device
into a PHONO level input.
2
3
4
5
the plastic
5