BorMann PRO BCP3050 Mode D'emploi page 5

EN
SPECIFICATIONS
Technical Data
BCP3050
Model
Power 600 W
Disc Diameter 50/70 mm
No load Speed 2000 - 6800 rpm
Eccentricity 7 mm
Functions Constant Speed, Soft Start
Rubber grip, 1 x 75mm backing plate, 1 x 50mm
Includes backing plate, 1 x wrench, 1 x 75mm foam pad, 1
x 50mm foam pad, 1 spare carbon brush set
OPERATION
WARNING! Read the entire Safety Precautions section at the beginning of this manual before setting up or using this product.
Installing the backing pad/foam pad
1. The accessory MUST be:
• Rated to at least 2000 RPM.
• No larger than 3" (75 mm) in diameter.
• Fitted with a threaded opening of 5/8" x 11 TPI.
• undamaged.
• a backing pad.
2. Press in and hold the Spindle Lock Button to prevent the Spindle from turning.
3. Thread the Backing Pad onto the Spindle until firmly secured in place.
Workpiece and work area set up
1. Designate a work area that is clean and well-lit. The work area must not allow access by children or pets to prevent distraction and injury.
2. Route the power cord along a safe route to reach the work area without creating a tripping hazard or exposing the power cord to possible damage. The power
cord must reach the work area with enough extra length to allow free movement while working.
3. Secure loose workpieces using a vise or clamps (not included) to prevent movement while working.
4. There must not be hazardous objects, such as utility lines or foreign objects, nearby that will present a hazard while working.
Polishing
1. Make sure the surface to polish has been thoroughly washed, and is free of dust, dirt, oil, grease, etc.
2. Place a clean Applicator securely onto the Backing Pad.
3. Apply about two tablespoons of wax (not included) evenly on the clean foam pad.
CAUTION! Do not apply the wax directly to the surface of the vehicle. The amount of wax needed will vary according to the size of the vehicle being
waxed.
4. Rotate the Speed Dial to select the desired speed between 1 and 4.
CAUTION! Only use the slower speeds (1 through 4) for polishing. Otherwise, damage may occur to the paint being polished. The manufacturer is not
responsible for damage to the vehicle's finish due to improper use of this Polisher/Sander.
5. Plug the Power Cord into an electrical extension cord (not included). Then, plug the extension cord into a grounded, RCD protected outlets.
WARNING! To prevent electric shock, keep cord connection away from the ground.
5
* The manufacturer reserves the right to make minor changes to product design and
technical specifications without prior notice unless these changes significantly affect the
performance and safety of the products. The parts described / illustrated in the pages of the
manual that you hold in your hands may also concern other models of the manufacturer's
product line with similar features and may not be included in the product you just acquired.
* To ensure the safety and reliability of the product and the warranty validity, all inspection,
repair or replacement work, including maintenance and special adjustments, must only be
carried out by technicians of the authorized service department of the manufacturer.
* Always use the product with the supplied equipment. Operation of the product with
non-provided equipment may cause malfunctions or even serious injury or death. The
manufacturer and the importer shall not be liable for injuries and damages resulting from
the use of non-conforming equipment.
WWW.NIKOLAOUTOOLS.COM