DewStop breeze easy F200-1W Guide D'installation page 10

WARNING: Disconnect the AC power before any work is done to any part of
the circuit Breeze Easy is connected to. If you do not understand this
warning, seek the services of a qualified licensed electrician.
WARNING: Copper to copper only. Do not use aluminum wire.
WARNING: Follow all local electrical and safety codes, and NEC (National
Electrical Codes).
CAUTION: If your house wires do not match these colors, determine what
each house wire represents before connecting. You may need to consult a
qualified licensed electrician to determine this safely.
4.) Attach conduit with wiring from CONTROL to HOUSING. Open the electrical
enclosure inside the fan HOUSING and connect wiring using the provided WIRE
NUTS, matching wire colours as shown:
green / green / yellow
5.) Place the included SUPPORT STRIPS on the sides of the cutout opening. If
one of the joists is already on the edge of the cutout opening, you will only need
to use one SUPPORT STRIP. Use 1-INCH FLATHEAD WOOD SCREWS
(included) to screw SUPPORT STRIPS into ceiling.
SUPPORT
STRIP
1-INCH FLATHEAD
WOOD SCREW
Qty:4
6.) Tilt housing up into ceiling. While tilted, reattach DAMPER through opening in
fan HOUSING. Next, use ROUNDHEAD WOOD SCREWS (included) to screw
HOUSING into ceiling where you placed the SUPPORT STRIPS.
DAMPER
and ducting
white / white
black / back
joist
or
ceiling
1-INCH FLATHEAD
WOOD SCREW
9
conduit (power
from CONTROL)
HOUSING
DAMPER
and ducting
SUPPORT
STRIP
Qty:2
WIRE
NUT
Qty:3
joist
ceiling