Publicité
Les langues disponibles
Les langues disponibles
English
15. Using the hook
The hook is used to hang up the power tool to your
waist belt while working.
CAUTION
● When using the hook, hang up the power tool
fi rmly not to drop accidentally.
If the power tool is dropped, it may lead to an
accident.
● When electing to carry the tool hooked to your
hip belt, make sure to detach the tool bit and side
handle.
Failure to do so may result in unexpected injury.
● Install securely the hook. Unless the hook is
securely installed, it may cause an injury while
using.
(1) Removing the hook.
Remove the screws fi xing the hook with Philips screw
driver. (Fig. 20)
(2) Replacing the hook and tightening the screws.
Install securely the hook in the groove of power
tool and tighten the screws to fi x the hook fi rmly.
(Fig. 21)
Hook
18
Groove
Screw
Hook
Fig. 20
Groove
Screw
Fig. 21
16. Reactive force control
This product features a reactive force control (RFC)
to minimize the danger of twisting the operator's arms
when tool itself suddenly jerks during operation.
When the tool bit is suddenly overburdened, the tool
itself may react to the motor's force and twist in the
opposite direction of the motor's rotation, which could
result in injury. (Fig. 22)
When the tool's built-in control detects a reactive
force, it stops the motor's output before the entire tool
jerks to lessen the twisting of the operator's arms.
When this function activates, it will be indicated by the
LED light blinking (0.1-second blinks/off 0.5 seconds)
while the switch is pulled.
(See "17. LED light warning signals")
However, as the function may not activate depending
on situations or conditions during operation, so care
should be taken to avoid any sudden overburdening
of the tool bit when operating the tool.
● Possible causes of sudden overburdening
Tool bit biting into material
Impact against nails, metal or other hard objects
Tasks involving prying or any excess application of
pressure, etc.
Also, other causes include any combination of the
aforementioned.
● When the reactive force control (RFC) is triggered
When the RFC is triggered and the motor stops, turn
off the tool's switch and remove the cause of the
overburdening before continuing operation.
Arms are twisted
Fig. 22
Publicité
