Metabo HPT DS 36DA Instructions De Sécurité Et Mode D'emploi page 15

7. Confi rm the clutch dial position (See Fig. 14).
<DS36DA>
The tightening torque of this unit can be adjusted
according to the clutch dial position, at which the
clutch dial is set.
Weak
mark
Strong
(1) When using this unit as a screwdriver, line up the one
of the numbers "1, 4, 7 ... 22" on the clutch dial, or the
dot, with the triangle mark on the outer body.
(2) When using this unit as a drill, line up the clutch dial
drill mark " " with the triangle mark on the outer
body.
CAUTION
● The clutch dial cannot be set between the
numbers "1, 4, 7 ... 22" or the dot.
● Do not use with the clutch dial set at the line
between the number "22" and the drill mark
" ". Doing so may cause damage (See Fig. 15).
mark
Line
Clutch dial
Triangle mark
Fig. 14
Triangle mark
Fig. 15
<DV36DA> (Fig. 16)
The three modes of screwdriver, drill and hammer drill
can be switched by the position of the clutch dial in
this unit.
(1) When using this unit as a screwdriver, line up the one
of the numbers "1, 4, 7 ... 22" on the clutch dial, or the
dot, with the triangle mark on the outer body.
(2) When using this unit as a drill, line up the clutch dial
drill mark " " with the triangle mark on the outer
body.
(3) When using this unit as a hammer drill, align the clutch
dial hammer mark " " with the triangle mark on the
outer body.
Weak
mark
mark
Strong
CAUTION
● The clutch dial cannot be set between the
number "1, 4, 7 ... 22" or the dot.
● Do not use with the clutch dial number at "22"
and the line at the middle of the drill mark. Doing
so may cause damage. (See Fig. 17)
mark
Line
8. Rotation to Hammer changeover (DV36DA)
The "Rotation (Rotation only)" and "Hammer (Hammer
+ Rotation)" can be switched by aligning the drill mark
" " or the hammer mark " " with the triangle mark
on the outer body.
English
Clutch dial
Triangle mark
Fig. 16
mark
Triangle mark
Fig. 17
15