Bigben Interactive TD94 Mode D'emploi page 12

Hints for best reception:-
- The receiver has a built-in bar antenna. If AM reception is weak. Slight rotate or re-positioning of
AM :
the unit will usually improve the AM reception.
The receiver has a built-in FM Wire Antenna (25) hanging at the rear cabinet. This wire should be
- FM :
totally unraveled and extended for best reception.
Listening to Phono
NOTED:
Remove the stylus protector.
-
Be sure that the tone arm is being detached from the tone arm rest before
-
operating and re-secured again after wards.
1. Select to "Phono" function from Function Selector(5)
2. Set the speed selector to the proper position depending on the record to be played.
3. Place the record on the platter(use the Spindle Adaptor if required).
4. Lift the tone arm from the rest and slowly move it to the record side. The platter will
start to rotate.
5. Place the tone arm to the desired position of the record.
6. Adjust the volume to the desired level.
7. At the end of the record, the platter will automatically stop rotating. Lift the tone arm
from the record and return to the rest.
8. To stop manually, lift the tone arm from the record and return it to the rest.
As some kind of record the auto-stop area was out of the unit setting, so it will stop before the
REMARK :
last track finish. In this case, select the Auto-Stop Switch (22) to "Off" position. Then it will run to the end of
the record but will not stop automatically.(Turn off the unit by power button or switch back the Auto-Stop
Switch(22) to "On" position to stop the platter rotate). Then put back the tone arm to the rest position.
Remark : Due to Aux and Phono were designed at the same position of this system. When Aux in jack(24)
plugged by 3.5mm plug. The channel will change to Aux automatically and turntable will stop to rotate.
Please ensure the Aux in jack (24) without plugged by anything before playing Phono.
Aux-in connection
Connect the unit to other device by connecting the Aux in jack (24) with a 3.5mm cable(not provided) and
other end connect to the external device such as Discman/MP3 player to perform the music playback or
encoding function etc.
1. Slide the Function knob(5) to Phono/Aux position.
2. Adjust the Power ON-OFF/ Volume Control Knob(16) to desired volume level.
3. Start to play your external device.
Playback of MP3 song via USB storage media or memory card
Connecting
The system is able to decode and playback all MP3 file which stored in the memory media with USB
connecting port or SD.MMC memory card.
Function knob (5) to USB or SD mode
1. Turn the
2. Plug-in the USB with the face up and make sure it going into
completely or insert the memory card in the direction of the arrow
as shown in the label on the upside of the memory card slot. Insert
straight without bending.
Connecting the USB upside down or backwards could
damage the audio system or the storage media (USB thumb
drive/SD/MMC Card). Check to be sure the direction is correct
before connecting.
3. The system will start reading and playback the file in the storage
media automatically after connecting and the Play LED indicator
(13) will light up .
Remark : USB port does not support connection with USB extension cable and is not designed for
communicate with computer directly.
4