Appendix; Selection Of Tip; Servicing And Cleaning Of Airless Hard-Metal Tips; Accessories - Titan Tool Elite 3500 0537012 Mode D'emploi

appendix

9
AppeNDIx
9.1

SelecTIoN of TIp

To achieve faultless and rational working, the selection of the
tip is of the greatest importance.
In many cases the correct tip can only be determined by means
of a spraying test.
Some ruleS for ThIS:
The spray jet must be even.
If streaks appear in the spray jet the spraying pressure is either
too low or the viscosity of the coating material to high.
remeDy: Increase pressure or dilute coating material. Each
pump conveys a certain quantity in proportion to the size of
the tip:
The following principle is valid:
There is a large range of tips with various spraying angles.
9.2
ServIcINg AND cleANINg of AIrleSS
hArD-meTAl TIpS
STANDArD TIpS
If a different tip type has been fitted, then clean it according to
manufacturer's instructions.
The tip has a bore processed with the greatest precision. Careful
handling is necessary to achieve long durability. Do not forget
the fact that the hard-metal insert is brittle! Never throw the tip
or handle with sharp metal objects.
The following points must be observed to keep the tip
clean and ready for use:
1. Follow the "Pressure Relief Procedure" found in the
Operation section of this manual, section 4.5.
2. Remove the tip from the spray gun.
3. Place tip in an appropriate cleaning agent until all coating
material residue is dissolved.
4. If there is high-pressure air available, blow out tip.
5. Remove any residue by means of a sharp wooden rod
(toothpick).
6. Check the tip with the help of a magnifying glass and, if
necessary, repeat points 3 to 5.
24
large tip = low pressure
small tip = high pressure
9.3

AcceSSorIeS

pArT No. DeScrIpTIoN
SprAy guNS
0538020 RX-Pro with TR-1 Tip
0538005 RX-80 4 finger with TR-1 Tip
0538006 RX-80 2 finger with TR-1 Tip
SprAy TIpS AND AcceSSorIeS
662-XXX SC-6+ Tip*
695-XXX TR-1 Tip*
692-XXX TR-2 Tip*
671-XXX Fine Finish Tip*
0289228 No Build Tip Guard
651-139 Tip Swivel
661-020 Tip seat and seal kit (5 pack)
fIlTerS
0089957 Coarse Mesh Filter (Green)
0089958 Medium Mesh Filter (White)
0089959 Fine Mesh Filter (Yellow)
0089960 Extra Fine Mesh Filter (Red)
exTeNSIoNS
651-070 6" Tip Extension
651-071 12" Tip Extension
651-072 18" Tip Extension
651-073 24" Tip Extension
310-390 3' Extension Pole
310-391 6' Extension Pole
AIrleSS hoSe AND AcceSSorIeS
316-505 1/4" x 50' Airless Hose
316-506 3/16" x 5' Whip Hose
490-012 1/4" x 1/4" hose connector
0508239 High Pressure Fluid Gauge
310-150 9" Pressure Roller Kit
0521012 Non-Spit Valve
luBrIcANTS AND cleANerS
314-482 Liquid Shield™ 1 Quart
0297055 Pump Shield™, 12 oz.
0508071 Paint Mate 1 Quart
* Go to www.titantool.com for tip sizes
Elite 3500