Technical Data - Pattfield Ergo Tools E-RT 25 D Mode D'emploi D'origine

Anleitung_E_RT_25_D_SPK7:_
damage.
Never attempt to cut grass that is not growing on
the ground. For example, do not try to cut grass
growing on walls, rocks, etc.
Within the working radius of the grass trimmer
the user is responsible for any damage caused
to third persons by use of the trimmer.
Never cross roads or pebble paths with the grass
trimmer switched on.
When you are not using the grass trimmer, keep
it in a dry place out of the reach of children.
Use the grass trimmer only as described in these
directions for use and always hold it vertical to
the ground. All other positions are dangerous.
Check the screws regularly to see that they are
properly tightened.
The mains voltage must be the same as the
voltage specified on the rating plate.
Check the power cable regularly for signs of
damage or aging. Never use the grass trimmer if
the power cable is in less than perfect condition.
Power cables used with the trimmer must not be
of a lighter duty class than HO7RN-F rubber-
insulated flexible cables according to DIN 57282
/ VDE 0282 with a minimum diameter of 1.5 mm
Plug connectors must be equipped with earthing
contacts and the coupling must be rain-water-
protected.
Keep cables and other objects out of the area
you want to cut.
If you have to lift the grass trimmer to move it,
switch off the motor and wait for the rotating tool
to stop. Before you leave the trimmer, switch off
the motor and pull out the power plug.
Before you connect the grass trimmer to the
power supply, make sure that none of its moving
parts are damaged and that the line spool is
correctly inserted and fastened.
Never cut against hard objects when using the
grass trimmer. This is imperative to avoid
causing injury to the user and damage to the
trimmer.
Use only original replacement parts for repair
and maintenance purposes.
Have repairs carried out only by a qualified
electrician.
Examine the grass trimmer for signs of wear or
damage each time before you use it and after
any collisions. Have essential repairs carried out
without delay.
Always keep your hands and feet away from the
cutting mechanism, particularly when you switch
on the trimmer.
After pulling out new line, always return the
trimmer to normal working position before you
switch it on again.
01.12.2010 12:34 Uhr Seite 11
Never use replacement parts or accessories
which are not foreseen or recommended by the
manufacturer.
Pull out the power plug before carrying out any
inspection, cleaning or other work on the trimmer
and whenever it is not being used.
Caution! The nylon line will run on for a few
seconds after the tool is switched off!
3. Description of the warning sign (see
Figure H) on the equipment
2 . Item 1: Important. Please read the operating
instructions carefully before using the
equipment.
Item 2: Wear safety goggles and a face guard.
Item 3: Do not use the equipment in the rain, in damp
conditions or on wet grass.
Item 4: Pull out the power plug before checking a
damaged power cable!
Item 5: Keep other people out of the danger area!

4. Technical data

Voltage
Power rating
Cutting width
Speed
Nylon cutting line
Sound pressure level L
Sound power level L
Vibration a
Protection class:
Weight
The machine may exceed 85 dB (A). The operator
will require noise protection measures if this is the
case. The noise generated by this machine was
measured in accordance with EN 786.
230V ~ 50 Hz
12,500 rpm
pA
WA
hv
GB
250 W
ø 24 cm
ø 1.2 mm
82 dB(A)
95 dB(A)
≤ 2.5 m/s 2
II/®
1.8 kg
11