Inserting Batteries Into The Dvd Remote Control (For Playstation ® 2) - Sony SCPH-10171 Mode D'emploi

Setup (continued)
z Inserting batteries into the DVD
remote control (for PlayStation
Insert the two, size AAA batteries (supplied) into the DVD remote control
paying attention to the plus and minus ends (polarity) as indicated in the
battery compartment.
Notes
• Incorrect use of batteries can result in battery content leakage or explosion.
When using batteries, be sure to abide by the following instructions:
– Make sure that the plus and minus ends of the batteries are inserted in the
correct directions.
– Do not mix old and new or different types of batteries.
– Do not attempt to recharge non-rechargeable type batteries.
– Remove the batteries when the DVD remote control will not be used for an
extended period of time.
– If battery contents have leaked, be sure to carefully remove all residue before
inserting new batteries.
• When using the DVD remote control, be sure that the IR receiver of the IR
receiver unit is not in direct sunlight or exposed to other strong light. The DVD
remote control may not function properly under such conditions.
12
2)
®