When The Dvd Video Is Finished; Operating The Dvd Player - Sony SCPH-10171 Mode D'emploi

Notes on the playback of DTS audio from a DVD video
DTS audio signal can only be output through an optical digital cable (sold
separately). Please note that it cannot be output through a regular audio cable.
• Do not set the "DTS" option of "Audio Digital Out" under "Audio Setup"
to "On" when using an audio component that does not have a built-in
DTS decoder. In such cases, if you play a DTS audio track, a loud noise
(or no sound) will come from the speakers, possibly hurting your ears or
damaging the speakers.
• When the "DTS" option of "Audio Digital Out" under "Audio Setup" is
set to "Off," the DVD's DTS audio output will not be played back, even if
you connect with an optical digital cable.
z When the DVD video is finished
1
Press the A (open) button on the PlayStation
2
Remove the disc.
3
Press the A button.
4
Press and hold the 1 (standby)/RESET button for about two
seconds.
Note
To save your changes, be sure to eject the DVD before pressing the 1/RESET
button or turning off the console with the MAIN POWER switch. Please note that
changes will not be saved if you reset or turn off the console without first ejecting
the DVD.
z Operating the DVD Player
The DVD Player can be operated in the following three ways:
• through the on-screen Control Panel
• directly with the DVD remote control
• directly with the analog controller (DUALSHOCK
Notes
• Depending on the disc used, some operations may vary or may not be possible.
• The method of operation for certain functions may vary depending on whether the
IR receiver unit is inserted into the PlayStation
2 console.
®
2).
®
2 console or not.
®
US
17