Scheppach C-CD45-X Mode D'emploi page 23

7. Processing time - We normally process complaint con-
signments within 14 days of receipt at our service cen-
tre. If, in exceptional cases, the processing time men-
tioned is exceeded, you will be informed in good time.
8. Wear parts are generally excluded from the war-
ranty! - Wear parts are: a) supplied, attached and/or
installed batteries / rechargeable batteries as well as
b) all model-dependent wear parts (i.e. belts, saw
blades, tool attachments, grinding discs, filters, carbon
brushes etc., see operating manual).
The warranty does not cover batteries or rechargeable
batteries that are deeply discharged or those with
damaged housing or battery terminals.
9. Cost estimate - Products that are not covered or no
longer covered by the warranty will be repaired at ex-
tra cost. Upon request to our service centre, you can
send in the defective products for a cost estimate and,
if necessary, give the service centre approval for the
repair in writing (by post, e-mail). No further process-
ing will take place without approval for the repair.
The warranty conditions only apply in the current ver-
sion at the time of the complaint and, if necessary, can be
found on our homepage (www.scheppach.com).
In case of translations, the German version is decisive.
Scheppach GmbH · Günzburger Str. 69 ·
89335 Ichenhausen (Germany)
Tel: +800 4002 4002 ·
E-Mail: customerservice.GB@scheppach.com ·
Internet: https://www.scheppach.com
We reserve the right to make changes to the warranty
conditions at any time without prior notice.
15 EU Declaration of Conformity
Translation of the original Declaration of Conformity
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
We declare under our sole responsibility that the product
described here complies with the applicable directives
and standards.
Brand:
Art. designation:
Item No.
EU directives:
2014/30/EU, 2006/42/EC, 2011/65/EU*
* The object of the declaration described above fulfils the
regulations of the directive 2011/65/EU of the European
Parliament and Council from 8th June 2011, on the re-
striction of the use of certain hazardous substances in
electrical and electronic equipment.
Applied standards:
EN 62841-1:2015/A11:2022;
EN 62841-2-1:2018/A12:2022;
EN IEC 55014-1:2021; EN IEC 55014-2:2021
Documentation authorised representative:
Georg Kohler
Günzburger Str. 69
D-89335 Ichenhausen
Ichenhausen, 20.06.2024
Simon Schunk
Division Manager Product Center
Andreas Pecher
Head of Project Management
www.scheppach.com
SCHEPPACH
CORDLESS IMPACT DRILL
C-CD45-X
5909236900
GB | 23