Publicité
+
Motor Shaft
Eje del motor
Arbre
d'entraînement
du moteur
+
Groove
Ranura
Ouverture
Agitator Shaft (Inside)
Eje del agitador (Dentro)
Arbre de l'agitateur
(à l'intérieur)
Replacing Belt
Install New Belt
Instalaciòn de la
correa
Poser la nouvelle
courroie
End Cap
Tapa del extremo
Bouchon
Cleaning Agitator
Remove worn or broken belt.
If end caps fall off, do not lose the
two (2) washers.
Clean agitator and reinstall the two
(2) washers and end caps.
Loop new belt (Panasonic Type UB8
only) around motor shaft and belt
pulley; see illustration for correct belt
routing.
Reinstall agitator back into nozzle
housing grooves.
After reinstalling the agitator, turn it
by hand to make sure that belt is not
twisted or pinched and that all
rotating parts turn freely.
Reinstall lower plate.
Clean agitator after every five uses
and every time the belt is replaced.
Remove lower plate.
Cut off any carpet pile and lint
entangled around agitator with a pair
of scissors.
Remove agitator.
Remove any string or debris located
on the end caps, washers or agitator
shaft.
Reinstall agitator and lower plate.
- 26 -
Publicité
