NAVEE T2208 Pro Manuel Utilisateur page 14

12. Trademark and Legal Statement
EN
is a registered trademark of Brightway Ltd., and all rights are reserved.
13. Safety Warning
WARNING
Sharp Edges
WARNING
Crush Hazard
14. Troubleshooting
Error Codes Reasons
10 Dashboard failure
11/12/28/29/40 Controller failure
14 Accelerator failure
15 Brake failure
18 Motor failure
21/24/39 Battery pack failure
45 Controller over temperature
50 Battery pack over temperature
Battery pack communication
52/53
fault, verification failure
23
WARNING WARNING
Hot Surface Do Not Disassemble
WARNING WARNING
Mind Your Hand Pinch Point
Solutions
Please timely contact after-sales service for detection and repair.
Please check that the accelerator is returned to its position, otherwise it
cannot run normally.
Please timely contact after-sales service for detection and repair if the
accelerator wiring harness is loose or damaged.
Please check that the brake lever is returned to its position, otherwise it
cannot run normally.
Please timely contact after-sales service for detection and repair if the
accelerator wiring harness is loose or damaged.
Please timely contact after-sales service for detection and repair.
Let the scooter cool down, and do not use it until the temperature has
returned to normal.
Try to restart the scooter to restore it. If it cannot be restored, contact
after-sales service for detection and repair.
15. Certification
FCC Supplier's Declaration of Conformity
This supplier's declaration of conformity is hereby for
Product: NAVEE Electric Scooter
Model Number(s): NKT2208-D32
Brand/Trade: NAVEE
We declare that the above mentioned device has been tested and found in compliance with CFR 47 Part Regulation.
Responsible Party—U.S.Contact Information
Company: Brightway Innovation Intelligent Technology (Suzhou) Co., Ltd.
Address: Building A2, Shangjinwan Headquarters Economic Park, No.2288, Wuzhong Avenue, Wuzhong Economic
Development Zone, Suzhou Jiangsu P.R. China
Country: China
FCC Compliance Statement for USA
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
FCC Note
Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
FCC Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.
EN
24