Ryobi RY408010BTL Manuel D'utilisation page 12

WARNING:
To prevent accidental starting, do not make any adjust-
ments or installations with the battery pack inserted.
Accidental starting of the snow blower during assembly
could result in serious personal injury.
UNFOLDING THE HANDLE ASSEMBLY
See Figures 2 - 3.
NOTICE:
Do not allow the chute rotation cable to become pinched
or trapped when raising the handles.
 Unlock the handle adjustment levers.
 Raise the upper handle. Avoid pinching or trapping any
cables.
 Return the handle adjustment levers to the locked posi-
tion to secure the handle in place.
ADJUSTING THE HANDLE ADJUSTMENT
LEVER
See Figure 3.
If the handle adjustment levers will not lock securely, the
handle adjustment knob on the inside of the levers needs
to be adjusted.
 Move the handle lock levers to the unlocked position.
WARNING:
Do not allow familiarity with products to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes resulting in possible
serious injury.
ASSEMBLY
 Adjust the handle adjustment knob until the handle ad-
justment levers will close securely in the locked position.
NOTE: Do not overtighten. The handle adjustment levers
should not require excessive force when placing them in
the locked position. If they are too tight, loosen the handle
adjustment knob slightly until the levers will lock.
 Move the handle adjustment levers to the locked position
to secure the handle in place.
INSTALLING CHUTE DEFLECTOR
See Figure 4.
 Insert the chute into the snow blower and turn it to the
unlocked position.
 Press and twist the chute deflector until the dot is in the
locked position and the release tab clicks into its locked
position.
 Insert the Phillips head screw into the screw hole and
tighten securely. Do not overtighten.
OPERATION
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.
NOTICE:
Before each use, inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps,
etc. Tighten securely all fasteners and caps and do not
operate this product until all missing or damaged parts
are replaced. Please contact customer service or an
authorized service center for assistance.
8 — English