Publicité
Les langues disponibles
Les langues disponibles
fIlTeR selecTIoN (continued)
2. Wet Application Cartridge Filter
a. The Wet Application Cartridge Filter is
catalog number WS24200F.
b. The Wet Application Cartridge Filter is
intended for cleaning up liquids and
wet debris only. It is NOT to be used
for any dry debris.
c. To maintain Filter performance, rinse
thoroughly with water after each use.
d. See "Filter Removal and Installation"
section for directions on how to
change the Wet Application Cartridge
Filter.
filter
WARNING: To reduce the risk of
injury from accidental starting, unplug
power cord before changing or
cleaning filter.
NoTe: The Filter is made of high quality
paper designed to stop very small
particles of dust. The Filter can be used
for dry debris or small amounts of liquid.
Handle the Filter carefully when removing
to clean or installing it. Creases in the
Filter pleats may occur from installation
but will not affect the performance of the
Filter.
Removal and Installation
of the Qwik lock™ filter
filter Removal:
1. Hold the Filter tabs of the Qwik Lock™
Filter in each hand.
3. Dust Collection Bags
mAINTeNANce
2. With one thumb on the Qwik Lock™
3. This action will cause the Filter to
filter Installation:
1. Carefully slide the Qwik Lock™ Filter
2. Align the small center hole in the top
16
(WS1200VAEX0 only)
a. The Dust Collection Bag for
Wet/Dry Vacuum model
WS1200VAEX0 is catalog number
WS32200F.
b. The Dust Collection Bag is intended
for cleaning up dry debris ONLY.
c. If the debris being picked up has
any moisture, the bag will absorb the
moisture and may deteriorate very
quickly, making the bag non-
functional.
d. If you are using your vacuum to pick
up fine dust, the Dust Collection Bag
will make cleanup easier.
Note: Dust Collection Bag MUST be
used in conjunction with a Pleated
Paper Cartridge Filter.
e. Directions for Installation and
Removal of Dust Collection Bags
are printed on the bags.
stud, which protrudes through the
integrated Filter plate, lift up on the
Filter tabs while pushing down on the
stud.
release from the filter cage. Slide
Filter off cage.
over the filter cage and press down on
the outside edge of the Filter until the
rubber gasket on the bottom of the
Filter seats securely around the base
of the filter cage and against the lid.
of the Filter over the Qwik Lock™ stud
on the filter cage. Press firmly on top
of the Filter near the stud to allow the
Filter to snap over the ball on the end
of the stud. The Filter is now attached.
Publicité
