Renkforce DS200-8M Mode D'emploi page 46

g) Setting the Film Type
This function is only available when the multi-scanner is in operating mode "FILM
SCANNER".
• Push the " " button (7) or the " " button (9) briefly repeatedly until the
corresponding submenu has been chosen; see figure on the right.
• Push the "ENTER" button (8) briefly to confirm.
• Select the desired film type (negatives, slides, black/white) with the " "
button (7) or the " " button (9).
• Push the "ENTER" button (8) briefly to confirm.
• Then the preview image will be displayed and you can scan images.
h) Setting up the Resolution
• Push the " " button (7) or the " " button (9) briefly repeatedly until the
corresponding submenu has been chosen; see figure on the right.
• Push the "ENTER" button (8) briefly to confirm.
• Select the desired resolution with the " " button (7) or " " button (9).
A resolution of 8 mega pixel corresponds to the resolution of the
internal sensor. When setting 16 mega pixels, the image is internally extrapolated.
If you have suitable image processing software, we recommend always setting the
resolution to "8M" (= 8 mega pixels) and to enlarge it with the software if necessary.
This can usually achieve better results since individual settings are possible depend-
ing on the software.
• Push the "ENTER" button (8) briefly to confirm. Then the preview image will be displayed and
you can scan images.
46