LIVARNO 409407 2207 Notice De Montage page 16

If the product is not screwed into
ground and wall, the manufacturer
accepts no liability whatsoever.
WARNING! Assembling the prod-
uct requires at least two people, due
to its size.
WARNING! As tools/machinery
need to be used, manual skills are
essential.
Suitable installation site
For ceiling installation, a concrete
ceiling or a load-bearing wooden
beam is suitable. For floor installa-
tion, a concrete foundation or con-
crete slab of at least 50 x 50 x 5cm
(L x W x D) is suitable.
Note: if you attach the product to
a wooden beam, you must fasten
the product to it firmly, as wood
warps depending on the temper-
ature and humidity. Enquire at a
specialist retailer about suitable
installation materials.
Note: alternative installation condi-
tions require inspection of load-bear-
ing capacity and durability by a
specialist company.
Assembly
The following tools (not included in
delivery) are required for assembly
of the product: a suitable drill, a
tape measure, an appropriate
screwdriver, and a hammer.
18 GB/IE
Note: For optimal support, the
ground and wall brackets must be
firmly screwed in.
1. Use an appropriate screwdriver
to fasten the wall brackets (3) with
the screws (4) to the side awning
(1) (fig. B).
2. Select a suitable assembly surface
on a wall and mark four holes for
the wall brackets (fig. C).
3. Use a drill to drill holes (Ø 8mm)
5cm deep at the positions marked
(fig. C).
Important: Be sure to use a
suitable material for the anchor
bolts (5).
4. Use a hammer to hammer the
anchor bolts into the holes pre-
drilled to mount the side awning
onto the wall. Tighten the anchor
bolts securely using a spanner.
Note: the anchor bolts must
be unscrewed from each other
before assembly.
5. Select a suitable assembly surface
on the ground and mark four
holes for the support post (2).
Important: When selecting
your location
make sure that side awning
and support post stand on level
ground. The support post must be
placed no more than 300cm from
the side awning.