Start-Up - GLW EC 65 Mode D'emploi

1. Selecting the installation site
 The installation site must be level and horizontal.
!
The conditions in the SAFETY chapter under Work Places must be observed.
2. Removing the protective cover
 Unscrew the screw (1).
 Pull off the protective cover (2).
3. Mounting the crimp die
Note installation position:
!
Small cross section at front.
Large cross section at back.
 Insert bottom die (1).
 Screw in screw (2) loosely.
 Insert top die (3).
 Screw in screw (4) loosely.
12/09

START-UP

Figure 3
Figure 4
Removing the protective cover
Mounting the crimp die
EC 65
8