Correct Use Of The Device; Danger Sources; Work Places; Protective Devices - GLW EC 65 Mode D'emploi

Correct use of the device

The EC 65 is designed exclusively for crimping work.
Only crimp dies with the matching cross sections according to the company supplementary
sheet may be used.
Never insert solid metal parts or similar objects; this would destroy the crimp die.
Unauthorised conversions which go beyond mere retooling and modifications to the EC 65 are
prohibited for safety reasons!
Correct use of the instrument includes observation of all the instructions and the
!
prescribed operating conditions.

Danger sources

The EC 65 may only be operated with the protective cover fitted.
The mains plug must be pulled out prior to doing any work which entails removing the protective
cover (e.g. adjusting the die). The device should be switched off at the mains switch during breaks
and when not in use.

Work places

The following places should be avoided for operation and storage:
 damp or dusty places,
 places exposed to high temperatures, direct sunlight or low temperatures
(operating range: 10°C to 40 °C).
Do not spill liquids onto the EC 65.
Do not expose the EC 65 to strong vibrations and impact.

Protective devices

The EC 65 is switched off by
 the mains switch (0 pressed, LED
 pulling out the mains plug.
 pulling off the protective cover.
The protective cover is fitted for the operator's safety. It may on no account be modified, removed
or bypassed by conversions.
A sign on the bottom of the instrument warns of potential dangers.
12/09
SAFETY
dark).
EC 65
2