Operating Components - Function - GLW EC 65 Mode D'emploi

Operating components – function
1 Control panel
LED-ready
LED-error
LED-service
Reset button
Enter button
Mode 1 button
Mode 2 button
Opening limit buttons
2 Piece counter
12/09
DESCRIPTION
Serves to select operating functions and display device
states
indicates standby state
indicates a preceding defective crimping or fault (a new
crimping cannot be triggered as long as the LED is
alight)
indicates that the EC 65 is due for servicing (to
guarantee consistent quality of the crimpings, the
instrument must be serviced by the manufacturer after
500,000 crimpings).
Sets the piece counter reading back to 0 when the
EC 65 is switched on.
Extinguishes the LED
Switches the EC 65 to mode 1 (LED lights). Crimping
takes place in one step in mode 1. The crimp die is fully
closed and reopened by pressing the foot switch.
Switches the EC 65 to mode 2 (LED lights). Crimping
takes place in two steps in mode 2. The crimp contact is
clamped in the crimp die but not crimped by pressing
the foot switch. The wire can now be inserted in the
crimp contact. The crimp die is fully closed and
reopened by pressing the foot switch a second time.
The opening of the crimp die can be changed by
pressing the upper (open) and lower (close) button. The
LEDs indicate the opening:
 4 LEDs alight:
 no LEDs alight:
Resetting only becomes active after the next crimping.
The counter records every completed crimping process.
999999
Crimpings aborted due to faults are not recorded. The
counter reading is stored for about 1 week when the
device is switched off.
. The EC 65 is ready.
max. opening
min. opening
EC 65
6