Publicité
FEATURES
15
14
13
12
11
Figure 1
Figura 1
Abbildung 1
1
Polypropylene dust cap - moisture and UV resistant.
2
Oversized NBR (Nitrile-butadiene Rubber) surround for linear controlled
long excursion.
3
Paper cone - moisture and UV resistant.
4
Custom stamped steel frame.
5
Vented Aluminum voice coil former (2.5" voice coil former).
6
8mm steel front plate.
7
Large 2 stack ceramic magnets. (Large single magnet on 10" models)
8
8mm steel back plate/pole piece T yoke assembly.
9
1.125" vent. Part of the enhanced voice coil cooling system (forced
convection).
10
PVC magnet protector.
11
High temperature Copper dual 2 ohm or dual 4 ohm voice coil.
12
Venting in voice coil former. Part of the enhanced voice coil cooling system
(forced convection).
13
Interlaced Conex spider with stitched and looped tinsel leads attached.
14
Spring loaded push terminals.
15
ABS Trim Ring.
© 2008 directed electronics—all rights reserved
1
10
9
2
3
8
4
5
6
7
3
Publicité
