LG TNS20220 Serie Manuel De L'utilisateur page 11

Les langues disponibles

2. Reversing and Reinstalling Refrigerator Door

Using a ¼" socket wrench, loosen and remove Hinge

Pin from the Middle Hinge Bracket. Remove washer

underneath the middle hinge and set aside.

NOTE: At this point the door will be loose. Slightly lift the

door and remove it.

Loosen and remove the two bolts and use the Phillips

head screwdriver to remove the Middle Hinge Bracket

from the refrigerator housing. Set parts aside.

Remove the washer from the Bottom Hinge Pin.

Using a ¼" socket wrench, loosen and remove the

Hinge Pin from the Bottom Hinge. Reattach the

Hinge Pin to the opposite side of the hinge.

NOTE: This is easier to do while the hinge is still

attached.

REFRIGERATOR INSTALLATION

Using a 3/8'' socket wrench with a 2-Inch extension

and screwdriver, loosen the two bolts and one screw, and

remove the Bottom Hinge from right side of the housing.

Remove the Decorative Caps on the bottom of the

refrigerator housing. You will need these holes for the

Bottom Hinge.

Move the Bottom Hinge to the left side of the housing,

keeping the same orientation, and reattach with the

two bolts and one screw. The ﬂat screw must be

placed on the exterior side of the hinge. Move the

Decorative Bolt to the hole on the lower right side

of the housing.

Turn the refrigerator door upside down on a

nonsc

to remove the Bottom Hinge Pin Insert Bracket

with the Hingr Pin Insert.

ratching surface. Loosen the two screws