Publicité
Les langues disponibles
Les langues disponibles
Pans do not
become hot and
appears in the
display.
The induction
hob or a
cooking zone
has turned itself
off
unexpectedly, a
tone sounds
and an error
code is
displayed
(typically
alternating with
one or two
digits in the
cooking timer
display).
Failure Display and Inspection
If an abnormality comes up, the induction hob will enter the protective state
automatically and display corresponding protective codes:
Problem
Possible causes
F3-F8
Temperature sensor failure
F9-FE
Temperature sensor of the
IGBT failure.
E1/E2
Abnormal supply voltage
E3/E4
Abnormal temperature
E5/E6
Bad induction hob heat
radiation
The above are the judgment and inspection of common failures.
Please do not disassemble the unit by yourself to avoid any dangers and
damages to the induction hob.
The induction hob cannot
detect the pan because it is not
suitable for induction cooking.
The induction hob cannot
detect the pan because it is too
small for the cooking zone or
not properly centred on it.
Technical fault.
Use cookware suitable for induction
cooking. See section „Choosing the
right cookware‟.
Centre the pan and make sure that its
base matches the size of the cooking
zone.
Please note down the error
letters and numbers, switch
the power to the induction hob
off at the wall, and contact a
qualified technician.
What to do
Please contact the supplier.
Please contact the supplier.
Please inspect whether power
supply is normal.
Power on after the power
supply is normal.
Please inspect the pot.
Please restart after the
induction hob cools down.
EN-22
Publicité
