Create Iron Flat 3000 Manuel D'utilisation page 8

STEAM IRONING
1. Fill the water tank following the instructions.
2. Plug in the iron.
3. Position the iron vertically and turn the temperature control knob to the steam position.
When steam ironing, the appliance must be set to the maximum temperature, otherwise,
the water will leak and drip from the soleplate.
4. Preheat the iron until the indicator light goes out. The light will turn off when the iron
reaches the indicated temperature.
5. Turn the temperature control knob to the required setting for each type of fabric.
You may start steam ironing.
SPRAY FUNCTION
Before using the spray feature, check the fabric label for ironing instructions; some fabrics
may become stained with moisture.
The spray feature is particularly helpful for removing stubborn wrinkles and where extra
dampening is needed. You can use the spray with both steam and dry ironing. Simply press
the Spray button whenever you need it.
BURST OF STEAM FUNCTION
This feature provides additional steam for removing stubborn wrinkles. You can use the
burst of steam with both steam and dry ironing.
Press the Burst of Steam button to release a blast of steam. You might need to press the
button several times to activate the system. Wait a few seconds to allow the steam to
penetrate the fabric before pressing the button again.
Note: For optimum steam quality, do not apply more than three successive bursts.
ANTI-SCALE FUNCTION
You're iron is equipped with an integral anti-scale system located inside the water tank to
eliminate impurities from the water and to reduce the problems connected with lime scale
build-up.
To prolong the working life of this system, please, follow these steps occasionally:
1. Unplug the iron and allow it to cool down.
2. Fill the cup provided with your iron to the 3/4 mark. Add 1 tsp. of salt and pour this
solution into the water tank.
3. Let the solution sit in the water tank for 15 minutes, gently shaking the iron occasionally.
Then empty it and repeat this step a second time.
4. Fill the tank with clean water to rinse it and empty it.
ANTI-DRIP FUNCTION
The principle of automatic selection of the steam according to the fabric selected reduces
the steam flow at lower temperatures and avoids water dripping from your iron onto the
fabric.
AUTO-STOP SAFETY FEATURE
The electronic system cuts off the electric power and the Auto-Stop warning light flashes
if the iron is left vertically on its heel for more than 8 minutes, or in a horizontal position for
more than 30 seconds, for your security.
To indicate that the iron has been switched off, the auto-stop indicator light will start
blinking. To restart the iron, just move it gently until the auto-stop pilot stops flashing. The
temperature pilot will light up.
E NGL I SH
8