Publicité
Les langues disponibles
Les langues disponibles
Troubleshooting
Problems
Cleaning is finished
but small dust
particles come out of
the brush.
Vacuum cleaner stops
operation during
cleaning.
Static electricity
occurs when cleaning
a thick and soft mat.
Product specification
Model
Power
Rated power consumption
Battery specification
Charging time
Cleaning time
(Default : MID)
ꞏ Charging and cleaning time may differ depending on the brushes and the conditions of use.
• After cleaning, operate the vacuum for 10 seconds or more on the
MAX setting to suction up the small dust particles.
• The vacuum cleaner's motor will shut off to prevent overheating:
- When the vacuum operates with a full dustbin.
- When the vacuum operates with suction part or brush clogged.
- When the Extension Crevice Tool is used for long hours.
• After correcting the cause of the problem, turn the product on
again. (This case may differ depending on the ambient
- temperature.)
• Some types of mats such as a (childcare center mat or a noise
prevention mat for between floors, etc.) may cause static
electricity.
- Move the brush on a normal floor for a while and clean again.
This should get rid of the static electricity.
Handy
Jet fit brush
Solutions
VS15A60****
100-240 V ~ 50-60 Hz
410 W
Lithium-ion 21.6 V, 1800 mAh, 6 cell
3.5 hours
Approximately 5 minutes (MAX) /
Approximately 20 minutes (MID) /
Approximately 40 minutes (MIN)
Approximately 5 minutes (MAX) /
Approximately 18 minutes (MID) /
Approximately 27 minutes (MIN)
English
19
Publicité
