inventiv INV-CSBL20-BM Notice De Montage page 41

G1
0
o
G2
H
I
LED light
ORIGINAL INSTRUCTIONS
4. CUTTING GUIDE (SEE FIG. G1, G2)
There is a cutting guide notch on the front of the base
plate for use with the parallel guide. For straight cuts,
use the 0º guide mark to align with your parallel guide
scale. For a 45º bevel cut, use the 45º guide mark to
align with your parallel guide scale. Securely clamp
the parallel guide. Always make a trial cut to check the
setting.
5. BEVEL CUTS
Follow the instructions in BASE PLATE ANGLE
ADJUSTMENT in ADJUSTING section to set required
bevel angle between 0° and 45°. Do not use the depth
of cut scale when making bevel cuts due to possible
inaccuracy.
45
o
6. HEX KEY STORAGE (SEE FIG. H)
The hex key provided can be placed on the base plate
under the motor housing and beside the parallel guide
lock knob.
Hex key
7. LED LIGHT/POWER-ON INDICATOR LIGHT
(SEE FIG. I)
This tool has a power-on LED light which comes
on when the saw is plugged into a power source. It
indicated that your tool is power on and increases
visibility-great for dark or enclosed area.
SAFETY AND OPERATING MANUAL
41