Publicité
Scanning process for 35 mm or 120 negatives using a digital
camera and the
1. If you are using the DigitaLIZA Max, remove the Backlight
Panel with Built-in 120 Film Holder [B] from the Smartphone
Stand [C] and put it on a flat surface.
2. If you are scanning 120 film, follow the steps in the previous
section to load your film into the Backlight Panel with Built-in
120 Film Holder [B].
3. If you are scanning 35 mm film, follow the steps in the
previous section to load your film into the 35 mm Film Holder
[A]. Put the 35 mm Film Holder [A] with film loaded on top of
the Backlight Panel with Built-in 120 Film Holder [B].
4. Place the Removable Spirit Level [A4] on the 120 Film Holder
Cover [B1] or into the Spirit Level Slot of the 35 mm Film
Holder [A].
5. Look at the Removable Spirit Level [A4] to make sure that the
scanning unit has been placed on a flat surface.
6. Set your digital camera above the scanning unit using a tripod
mounted at a suitable distance to prepare for scanning.
7. Press the Backlight On/Off Switch [B2] on the Backlight Panel
[B3] to turn the Backlight Panel [B3] on.
8. Take the Removable Spirit Level [A4] and place it on top of
your digital camera's monitor.
9. Look at the Removable Spirit Level [A4] again, then adjust your
tripod until your digital camera is perfectly level and the film
frame is centered on your digital camera's monitor. You are now
ready to start scanning.
10. If you are scanning a negative image, you can invert your im-
age using imaging apps or imaging software on your computer
(please refer to the suggestions at lomography.com).
DigitaLIZA+
or
DigitaLIZA Max
8
Publicité
