Publicité
MANUAL STEPS - Before using
Installing batteries into the Backlight Panel with Built-in 120 Film
Holder [B]
1. Slide the Battery Door [B5] open.
2. Insert 2 x AA batteries into the Battery Chamber [B6].
3. Close the Battery Door [B5] by sliding it back into place.
Using the Backlight Panel with Built-in 120 Film Holder [B] with a
micro-USB power supply
1. Plug a standard micro-USB cable into the Micro-USB Socket [B4]
on the Backlight Panel with Built-in 120 Film Holder [B].
2. Plug the standard micro-USB cable into a USB power supply
(adapter or power bank).
Setting up the Smartphone Stand [C] included with the DigitaLIZA
Max
1. Set up the Smartphone Stand [C] for use by inserting the
Smartphone Holder Column [C5] into the Smartphone Column Slot
[C4] of the Base Plate [C1].
2. Insert the Smartphone Column Screw [C3] into the Base Plate [C1]
and tighten it by turning it clockwise until the Smartphone Holder
Column [C5] is steady.
3. Follow the steps in the next section for scanning your negatives
using any smartphone.
4. To uninstall the Smartphone Column [C]: loosen the Smartphone
Holder Column [C5] by turning the Smartphone Column Screw
[C3] counterclockwise. Remove the Smartphone Holder Column
[C5] from the Smartphone Column Slot [C4] of the Base Plate [C1].
6
Publicité
