Casselin CPC60 Mode D'emploi page 19

6.4 Troubleshooting
Your appliance is provided with an overheating protection. When this protection has been activated you must
let your appliance cool down.
ADVICE
If overheating protection has been activated let your appliance cool down.
If your appliance does not start check the power cord.
The use of adaptors, multiple sockets and/or extensions is not recommended.
For any other anomaly contact your supplier.
ADVICE
Waste Electronic and Electric Equipment
To avoid any abuse and dangers and to fit the rules of the concerned countries before disposing of the used
appliance you must remove main electric cable.
7. IF OPERATING ANOMALIES OCCUR.
ANOMALIE
The appliance does not
function and the heating
indicator is not lighted.
The appliance is on but it
does not heat. The heating
indicator is not lighted.
The required temperature is
not
The heating element
stopped without reaching
the required temperature
ADVICE
These anomalies are indications. If you cannot solve the problem following these instructions, contact your
retailer.
CAUSES
>The power cord is unplug.
>The fuse of the power supply
started or is defective.
>The control unit does not function.
>The high limit thermostat in on.
>High limit thermostat is damaged.
>The high limit thermostat is started.
>The heating element is damaged.
>The contact with the heating
element is damaged.
>The thermostat is damaged.
>The high limit thermostat is
started.
19
EXPLICATION
>Plug the power cord.
>Control the fuses.
>Check the position of the control unit.
>Press the reset button on the back
side of the appliance.
>Contact your retailer.
>Contactez votre revendeur.
>Contact your retailer.
>Press the reset button.