Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION INSTRUCTIONS
Water connection, continued (Steam Model only)
5 If your installation has room for the COLD water
supply to accept the "Y" connector directly, thread
the "Y" connector to the COLD water supply and
snug it by hand; then tighten it another 2/3 turn
with pliers.
NOTE
If you were able to install the "Y" connector directly to
the COLD water supply, please skip to step 8.
6 If there is not room to install the "Y" connector
directly, thread a short extension hose on to the
COLD water supply and snug it by hand; then
tighten it another 2/3 turn with pliers.
NOTE
Short extension available from your local hardware
supplier. Extension hose must meet qualifi cations for
use in laundry installation.
7 Thread the "Y" connector to the short extension
hose and snug it by hand; then tighten it another
2/3 turn with pliers.
8 Connect the COLD inlet hose for the washer to the
"Y" connector and snug it by hand; then tighten it
another 2/3 turn with pliers.
9 Connect the straight end of the long hose from the
kit to the other outlet on the "Y" connector and
snug it by hand. Connect the hose's 90° coupling to
the brass water inlet on the back of the dryer and
snug it by hand. Tighten each connection of the
dryer inlet hose another 2/3 turn with pliers.
10 Turn on the water and check for leaks at all
connections.
16
DIRECT CONNECTION
OR WITH EXTENSION*
COLD WATER SUPPLY
HOSE TO WASHER
*Laundry hose extension not included with dryer.
WATER INLET
ON DRYER
Publicité
