Publicité
Les langues disponibles
Les langues disponibles
HDE4E
5. Set up
Hose clamps are not completely tight.
Please tighten hose clamps prior to using.
Hose clamps are left loose to extend life
of gaskets and fittings.
Oil cap gasket before using and
lubricate weekly so the gasket will seal
properly and prevent chemical leaks.
Oil check valve and keep breather
hole clear of debris. Your failure to oil
may cause the tank to collapse
and crack due to vacuum created by
pump lubricate with "3 and 1" oil.
Make sure to insert the locking pin for the
pump handle in its (only) CORRECT
POSITION.
Fig. 1
The pin limits the pump stroke for
optimum performance.
Observe Fig. 1 exactly. (Fig. 2 and 3 spell
trouble.)
For best results and to maintain a good
seal, re-grease piston sleeve periodically
Fig. 2
with vaseline or similar light lubricants.
Fig. 13
US-6
HOW TO ASSEMBLE
1. Attach spray wand to spray gun and
tighten firmly.
2. Take pump handle part number
577 11 79-01 and insert into the tube on
the pump lever part number
574 14 96-01, you will notice holes drilled
through both sides of both the pump
handle and the pump lever. Align these
holes, take the "R" pin provided and
place through the holes. This affixes the
handle in place and is ready for use.
For storage reverse process and then
place "R" pin through the pump lever
to keep from losing "R" pin.
3. Instructions for installing shoulder strap
plastic buckle:
First put the sprayer on a hard flat
surface, take the white plastic buckle
and while holding the sprayer up
slightly, place buckle under the tubular
metal frame. Slowly push down forcing
the frame into the buckle. Repeat the
same procedure for other side.
Publicité
