Braun 790 cc-4 Instructions D'utilisation page 5

Description
Clean&Renew station
1
Cleaning fl uid display
2
Lift button for cartridge exchange
3
Station-to-shaver contacts
4
Start button
D
Fast clean button
5
Cleaning program indicators
6
Station power socket
7
Cleaning cartridge
Shaver
8
Foil & Cutter cassette
9
Cassette «release» button
0
Shaver head «lock» switch
q
Pop-out long hair trimmer
w
On/off switch
e
(–) setting button (sensitive)
r
(+) setting button (intensive)
t
Reset button
z
Shaver display
u
Shaver-to-station contacts
i
Shaver power socket
o
Travel case
p
Special cord set
Before shaving
Prior to fi rst use you must connect the shaver to
an electrical outlet using the special cord set
or alternatively proceed as below.
Installing the Clean&Renew station
• Using the special cord set
station power socket
• Press the lift button
• Hold the cleaning cartridge
stable surface (e.g. table).
• Carefully remove the lid from the cartridge.
• Slide the cartridge into the base of the station
as far as it will go.
• Slowly close the housing by pushing it down
until it locks.
The cleaning fl uid display
fl uid is in the cartridge:
up to 30 cleaning cycles available
up to 7 cleaning cycles remaining
new cartridge required
p
, connect the
6
to an electrical outlet.
2
to open the housing.
7
down on a fl at,
1
will show how much
p
1
2
5