Publicité
S P E A
6
1
U T
I N P
O U T
K E R S
POSITIONING
Because low-frequency sound reproduced by the powered
subwoofer is mostly non-directional, the listener will be unable to
localize the bass source. Accordingly, the powered subwoofer
provides maximum flexibility in terms of positioning. For the most
effective low-frequency sound, the powered subwoofer should be
placed on the floor close to a wall or in a corner of the room.
CONNECTIONS
Connect the speaker cords before connecting the AC cord.
Connect in A way if your stereo system has a SUPER (SUB)
WOOFER output jack. If not, connect in B
Never connect in both of A
A
A
A
A Connecting an AIWA stereo system with
A
a SUPER WOOFER or SUB WOOFER
output jack (RCA phono jack) to the
powered subwoofer
Preparations
Turn off the power of this unit.
1 Connect the SUPER WOOFER or SUB WOOFER jack on the
stereo system a to the INPUT 1 (FROM SUPER WOOFER
TERMINAL) jack on the powered subwoofer b with the supplied
connecting cord.
2 Set the INPUT SELECT switch to "1".
B
B Connecting a stereo system with typical
B
B
B
L and R speaker terminals to the powered
subwoofer
Preparations
Turn off the power of the stereo system and remove the speaker
cords from the speaker terminals on the system.
1 Connect the speaker terminals on the stereo system a to the
INPUT 2 (FROM SPEAKERS OUT) terminals on the powered
subwoofer b with speaker cords c (not supplied).
Make sure the L and R and the ) and ( cords are connected
correctly.
2 Using the speaker cords removed in "Preparations" above,
connect the right and left speakers d e to the SPEAKERS
OUT terminals on the powered subwoofer b.
3 Set the INPUT SELECT switch to "2".
Connecting the AC cord
Connect the AC cord to a wall outlet.
Use left/right speakers whose impedance corresponds with the
value specified on the stereo system.
B
B way.
B
B
A and B
A
A
A
B
B
B ways simultaneously.
B
Publicité
