Rehasense Navigator Air Mode D'emploi page 6

•
After unfolding or assembling the rollator always ensure that the seat support is securely locked by
the pulling strip mechanism for securing the lock and that the frame does not move anymore.
•
Always ensure that both arm support inner tubes are securely locked in the main frame tube with the
two wing knobs to prevent the accidental sliding in of the inner tubes when forced.
•
Always test that both armrests are set on the same height and that they are properly fastened on top
of the inner tube. It is not allowed to use a defective device.
•
Always make sure that after everything has been secured, nothing can move.
•
Always test to see that the rollator and attachments are properly and safely locked in place BEFORE
using.
•
Failure to follow these warnings can result in personal injury.
Folding

Disconnect the stabilization strap (3)

Disconnect the backrest in the middle (4)

Pull at the pulling strap on the seat to fold the rollator.

Fold the rollator until the red button locks
-
Before the rollator is folded and locked, one of the forearm supports must be set to a minimum
of three steps higher. See pictures 2 and 3.
Adjusting the height of the forearm supports

Disconnect the stabilizing straps

Disconnect the backrest (4) in the middle -
locking knob

Make adjustment of the forearm supports to your desired height.
11 / 2023
Release the height adjustment's
6