YATO YT-8300 Mode D'emploi page 8

PROPERTIES OF THE PRODUCT
The rectifi er is a device that permits to charge any kind of accumulators. The rectifi er converts the current and voltage in the power
network so as to guarantee a safe charging of accumulators. Charging facilitates a proper functioning of an accumulator, which
signifi cantly extends its life.
The rectifi er is equipped with a short-circuit protection and an overcharge protection.
A correct, reliable and safe functioning of the device depends on its proper use, so:
Before you proceed to operate the device, read the manual thoroughly and keep it.
The supplier will not be held responsible for any damage resulting from the safety regulations and the recommendations indicated
hereby not being observed.
The indicators in the housing of the device are not meters, as the notion is construed in the „Measurement Act"
TECHNICAL DATA
Parameter
Catalogue number
Power network voltage
Power network frequency
Power network current
Nominal charging voltage
Charging current
Accumulator's capacity
Insulation class
Protection grade
Mass
GENERAL SAFETY CONDITIONS
The device has not been designed to be used by persons (including children) of impaired
physical, sensory or mental capabilities, or those who lack the necessary experience and
knowledge, unless they are supervised or they have been trained in operation of the device
by the safety personnel.Preclude children from playing with the device. The rectifi er has
been designed to charge exclusively lead-acid accumulators. Charging any other type of ac-
cumulators may lead to an electric shock, which is dangerous for health and life.It is prohibit-
ed to charge non-rechargeable batteries! During charging the accumulator must be placed in
a well ventilated area. It is recommended to charge the accumulator at a room temperature.
The rectifi er has been designed to be operated in interiors, and it is prohibited to expose it
to humidity, including atmospheric precipitation.Electric Insulation Class I rectifi ers must be
connected to sockets equipped with a protection conductor.While charging accumulators in
the electric system of a car, fi rst the terminal of the rectifi er must be connected to the terminal
of the accumulator, which is not connected to the chassis of the vehicle, and then connect the
other terminal of the rectifi er to the chassis away from the accumulator and the fuel system.
Then connect the plug of the rectifi er to the power supply socket.Once the accumulator has
been charged, disconnect the plug of the rectifi er from the power supply socket, and then dis-
connect the terminal of the rectifi er. Never leave the rectifi er connected to the power supply
network. Always remove the plug of the power cord from the power supply socket.Observe
the polarity indications of the rectifi er and the accumulator. Before you commence charging
the accumulator, get acquainted with the charging instructions provided by the manufacturer
O R I G I N A L
8
EN
Measurement unit
[V AC]
[Hz]
[A]
[V DC]
[A]
[Ah]
[kg]
I N S T R U C T I O N S
Value
YT-8300
220 - 240
50
0.65
6/12
1 / 4
0 - 200
II
IPX0
0.6
YT-8301
220 - 240
50
0.8
6/12
8
5 - 200
II
IPX0
0.9