YATO YT-8300 Mode D'emploi page 10

YT-8300
Accumulator 6 V / 12 V
GEL
AGM
WET
YT-8301
Accumulator 6 V
/ 12 V
GEL 2 A for the capacity of the accumulator amounting to 5 - 200 Ah
AGM 2 A for the capacity of the accumulator amounting to 5 - 40 Ah
WET 2 A for the capacity of the accumulator amounting to 5 - 40 Ah
In case 6 V accumulators are being charged, it is not possible to adjust the charging current and it is independent of the option
selected with the „STEP 3" button.
Once all the options have been adjusted, the „READY" diode goes on – press the „GO" button in order to commence charging.
When the rectifi er starts charging, the „CHARGE" diode will go on. If for any reason it is not possible to commence the process of
charging, the „FAULT" diode will go on.
Press the „GO" button again in order to interrupt the process of charging, and set all the parameters again.
The diodes described as „20%", „50%", „70%", „90%" and „FULL" inform of the successive stages of the charging process of the
accumulator.
Initial charging (20% - 70%) – at this stage the rectifi er provides the maximum charging current to the accumulator, until the
programmed voltage of the accumulator has been reached; then it proceeds to the second stage.
Absorption charging (70% - 90%) – at this stage the voltage of charging is constant, and the charging current is gradually dimini-
shing in order to optimise the process of charging.
Conservation charging (90% - FULL) – the accumulator is being charged with a conservative current. The microprocessor of the
controller prevents the accumulator from overcharging. Once the process of charging has concluded, the rectifi er is automatically
disconnected.
Once the process of charging has concluded, fi rst disconnect the plug of the power cord from the power supply socket, and then
disconnect the terminals of the charging cables.
MAINTENANCE OF THE DEVICE
The device does not require any special maintenance. A dirty housing should be cleaned with a soft cloth or with a compressed
air jet, whose pressure must not exceed 0.3 MPa.
Check the conditions of the terminals of the conductors before and after each use. Remove any signs of corrosion, which might
disturb the fl ow of the electric current. Avoid contamination of the terminals with the electrolyte from the accumulator, since it would
accelerate the process of corrosion.
The device should be stored in a dry place, away from unauthorised persons, particularly children. Make sure the cables and
conductors are not damaged during storage.
O R I G I N A L
10
EN
1A
Capacity of the accumulator: 0 - 40 Ah
Capacity of the accumulator: 0 - 20 Ah
Capacity of the accumulator: 0 - 20 Ah
SLOW
I N S T R U C T I O N S
Capacity of the accumulator: 40 - 200 Ah
Capacity of the accumulator: 20 - 200 Ah
Capacity of the accumulator: 20 - 200 Ah
FAST
6 A for the capacity of the accumulator amounting to 20 - 200 Ah
8 A for the capacity of the accumulator amounting to 20 - 200 Ah
8 A for the capacity of the accumulator amounting to 20 - 200 Ah
4A