Publicité
3-1. Specifications
Type of Input
Welding Power
Power
Source Type
24 Volts AC
Constant Voltage (CV)
Single-Phase
DC With 14-Pin that provides
10 Amperes
voltage and current feedback
50/60 Hertz
Maximum Height With 4 ft (1.2 m) Post
Vertical Lift Of Boom
NOTE
4-1. Installing Swivel Into Pipe Post
Tools Needed:
3/4 in
SECTION 3 − INTRODUCTION
Wire Feed Speed
Range
Standard: 50 To 1400
ipm (1.3 To 35.6 mpm)
12 ft (3.7 m) Boom
17 ft (5.2 m)
Horizontal to 60° Above Horizontal
If feeder is used with a welding power source that does not provide voltage and
current feedback through the 14-pin control cable, run-in will be disabled. Arc
voltage will not be displayed on feeders equipped with meters.
SECTION 4 − INSTALLATION
2
1
Wire Diameter
Welding Circuit
Range
.023 To 5/64 in (0.6
100 Volts,
To 2.0 mm)
750 Amperes, 100%
Duty Cycle
Max Spool Weight:
60 lb (27 kg)
Horizontal to 60° Above Horizontal
Y Do not remove Safety Collar
5
1
4
2
3
Secure as shown using as a mini-
mum 1/2 in diameter SAE grade 5
steel bolts.
4
Insert into pipe post. Lubricate
3
swivel.
5
Weight
Rating
12 ft (3.7 m):
207 lb (94 kg)
16 ft (4.9 m):
280 lb (127 kg)
16 ft (4.9 m) Boom
21 ft (6.4 m)
until instructed to.
Swingpak Base or CBC Cart
Pipe Post With Base
Steel Bolt
Swivel Assembly
Safety Collar
152 268-B
OM-230 300 Page 9
Publicité
