Knick Stratos Evo A402N Mode D'emploi page 27

Selecting the Measuring Function
27
Start-Up
Upon initial start-up, the analyzer automatically recognizes the module and adjusts
the software correspondingly. When you replace the measuring module, you must
select the corresponding measuring function in the "Service" menu.
This does not apply to the multi-channel module for dual conductivity measure-
ment. Here, you will be prompted to select the desired measuring function upon
fi rst start-up.
Changing the Measuring Function (Memosens Sensors)
Directly connected Memosens sensors (without measuring module):
In the "Service" menu you can select another measuring function at any time.