Publicité
Les langues disponibles
Les langues disponibles
To attach the middle module to the handle
module and saw head module:
1. Align the groove on the outside of the
coupling end of the handle module (A)
with the tongue on the inside of the
coupling end of the center extension (B).
See figure 14. Push the two sections
completely together.
2. Slide the threaded sleeve (6) (figure 15)
on the center extension down as far as
possible and rotate the sleeve clockwise
until it stops and completely covers the
orange threads as shown in figure 16.
3. Repeat steps 1 and 2 above to attach the
saw head module to the center extension.
WARNING:
Always check to
make sure that the sleeve is completely
threaded on and that the orange threads are no longer visible. Not
threading the sleeve completely on could result in the modules
becoming disconnected creating a hazardous condition. Periodically
check the connections to insure that no orange threads are visible.
DISASSEMBLY
Detaching Saw Head Module
WARNING:
Sharp moving blade. To prevent accidental
operation, insure that battery is disconnected from the handle
and that the protective scabbard is in place on the
chain before performing the following operations.
Failure to do this could result in serious personal
injury.
When detaching the modules, whether it is in the two
module or three module mode, always detach the
saw head module first. To do this, rest the handle
module on the ground and grasp the center of the saw
head module with one hand figure 17. Use your other
hand to loosen the threaded sleeve figure
14
18 and then pull the two halves apart.
Repeat this process if the center extension
was attached.
Groove
15
follow all instructions listed below may result in electric shock, fire
and/or serious personal injury.
16
finishing work. The chain contracts as it cools down. If it is not
slackened off, it can damage the Pole Saw.
IMPORTANT: Never operate a Pole Saw that is damaged
or improperly adjusted or that is not completely and securely
assembled. Be sure that the saw chain stops moving when the trigger
switch is released. Never adjust the guide bar or saw chain when the
motor is operating.
Connecting the Battery
Place the battery in the tool as shown in figure 19 and be certain
that it is inserted fully into the tool cavity until it "clicks" into place. To
remove the battery from the tool, press down on the release button
on the back of the battery (figure 20) and slide out.
19
17
12
OPERATING THE POLE SAW
WARNING:
Read and understand all instructions. Failure to
CAUTION:
Always reduce the tension off the chain again after
18
20
Publicité
