Jennair JDA7000WX Instructions D'utilisation Et D'installation page 5

For a 30" (76.2 cm) base cabinet: The template will be located
in the front left corner. Note the area to be cut out of the cabinet
floor is in the toe-kick area.
Top View of Cabinet
E
D
B
A. Front of cabinet
B. Area to be cut out
C. Toe kick
For a 36" (91.4 cm) base cabinet: The poster board template
will be located closer to the center of the cabinet. Note the area
to be cut out of the cabinet floor is in the toe-kick area.
Top View of Cabinet
E
B
A. Front of cabinet
B. Area to be cut out
C. Toe kick
NOTE: For illustration purposes, the cabinet front is not shown
in most of the following illustrations.
IMPORTANT: Do not cut the cabinet front.
C
A
D. Template
E. Left side of cabinet
D
C
A
D. Template
E. Left side of cabinet
Cutout Steps
1. Use the framing square and draw a line on the cabinet floor
parallel to the edge of the blower exhaust scroll.
Top View of Cabinet
A
B
A. Blower exhaust scroll
B. Framing square
C. Cabinet floor
2. Flip the framing square over and slide it against the cabinet
front.
3. Extend the line made in Step 1 to the cabinet front.
NOTE: For clarity, the cabinet front is not shown in this view.
4. Locate template included with the installation kit.
A. Pilot hole locations
B. Alignment notch
5. Center the line made in Step 3 within the alignment notch of
the template. Make sure the edge of the template is against
the cabinet front.
C
A
B
5