Jennair JDA7000WX Instructions D'utilisation Et D'installation page 3

NOTE: There are 3 different styles of blowers. See the following
illustrations.
Blower Style A: With Top Label
D
E
C
A
F
A. Blower exhaust scroll
B. Plenum
C. Blower motor
Blower Style B: Without Top Label
B
A
A. Blower exhaust scroll
B. #10-32 machine nuts (4)
C. Plenum
Blower Style C
B
A
E
A. Blower exhaust scroll
B. #10-32 machine nuts (4)
C. Plenum
E
B
D. Top label
E. #10-32 machine nuts (4)
F. Motor mounting plate
B
C
D
E
D. Motor mounting plate
E. Blower motor
B
C
D
D. Motor mounting plate
E. Blower motor
To rotate blower motor (blower style A only):
NOTE: The "Top" label location on the blower motor is at the
9 o'clock position.
1. Using a ratchet with a /
3
with one hand, remove the 4 machine nuts that attach the
blower motor to the exhaust scroll.
2. Remove the blower motor and wheel assembly from the
weld studs.
D
A
B
E
C
A. Top label
B. Blower motor
C. Motor mounting plate
3. When the motor mounting plate clears the threaded weld
studs, rotate the assembly clockwise 90° and reinstall the
four #10-32 machine nuts.
4. Verify the "Top" label is positioned as shown.
A
A. Top label
To rotate blower motor (blower style B only):
1. Locate the 4 plastic plugs in the plenum bypass.
2. Use the pliers to remove the plastic plugs.
IMPORTANT: Do not throw away the plastic plugs. The
plastic plugs must be reinstalled after the blower exhaust
scroll has been rotated.
A
B
C
A. Blower motor
B. Blower exhaust scroll
C. Plenum
" socket and supporting the motor
8
D. Weld stud location
E. Blower wheel
E
D
D. Plenum bypass
E. Plastic plugs (4)
3