• Do not pull the plug from the socket with wet hands or by holding on to
the power cord.
• Do not use the appliance in immediate vicinity of a bath tub, a shower or a
swimming pool (observe a minimum distance of 3 m). Place the appliance
such that a person in the bath tub cannot touch the appliance.
• Do not place the appliance near a heat source. Do not subject the power
cord to direct heat (such as a heated hotplate, open flames, hot iron sole
plates or heaters for example). Protect power cords from oil.
• See to it that the appliance is properly positioned to ensure a high stability
during its operation and make sure that no one can trip over the power
cord.
• The appliance is not splash-proof.
• For indoor use only.
• Do not store the appliance outdoors.
• Store the appliance in a dry place inaccessible to children (pack the ap-
pliance).
• If the power cord is damaged, it must be replaced by the manufacturer
or a repair shop authorized by the manufacturer or by similarly qualified
persons in order to avoid a hazard.
• Prior to any maintenance, cleaning and after each use, switch off the appli-
ance and unplug the cable from the socket.
• Repairs to electrical appliances must only be carried out by a qualified
electrical technician.
• Only use the adapter provided by the manufacturer.
• Do not use fragrances, aroma or essential oils. These can damage the plas-
tic material and cause the appliance to malfunction. Appliances that are
damaged by such additives are not covered by the warranty.
Before setup
A. Take the travel bag (1) and the bag containing the adapter and cable (2)
out of the packaging. Open the travel bag (1) and take out the bottle (3).
B. Now turn the lid (4) to open the bottle and take the housing (5) out of the
bottle.
C. Fold out both of the supporting feet (6) to improve the stability of the ap-
pliance when the bottle is full.
D. Important! Water in the water tray (11) can get into the air outlet opening
(15) and cause the appliance to leak in the following situations: if the
appliance is carried around when the water tray (11) / water bottle (3) is
full / if the bottle (3) is removed and put back several times (letting water
run into the tray too often will cause it to overflow / if the water tray (11)
is tilted sideways when removing the bottle at an angle and water gets
into the air outlet opening in the process. It is therefore always important
to make sure that the water tray is carried in an upright position and the
bottle is removed from the tray by lifting it straight up rather than at an
angle.
Setting up / operation
1. Place Emma in the desired location, on a flat surface. Connect the USB
cable (7) to the power adapter (8) and to the housing (9) and insert the
adapter into a suitable mains socket. Alternatively, you can also connect
the USB cable to another power source such as an external battery pack/
powerbank with at least 2A.