Audio Settings - Pioneer MVH-S300BT Mode D'emploi

Menu Item
STOP

AUDIO settings

Menu Item
EQ SETTING
[SUPER BASS], [POWERFUL],
[NATURAL], [VOCAL],
[CUSTOM1], [CUSTOM2],
[FLAT]
Select an equalizer band and
level for further customizing.
Equalizer band: [50HZ] to
[12.5kHZ]
Equalizer level: [–6] to [+6]
FADER*1
BALANCE
SUBWOOFER
[ON], [OFF]
SUBWOOFER*2
[NOR], [REV]
Description
Stop playback.
Description
Select or customize the equalizer curve.
• When you select a setting other than
[CUSTOM1] and [CUSTOM2], you can also
customize the equalizer curve by pressing
and holding the M.C. dial, then store the
customized equalizer curve in
[CUSTOM1].
Adjust the front and rear speaker balance.
Adjust the left and right speaker balance.
Set to [ON] when using a subwoofer
speaker.
Select the subwoofer phase.
Menu Item
SPEAKER LEVEL
Types of speaker: [FRONT L],
[FRONT R], [REAR L], [REAR R],
[SUBWOOFER]
Output level: [–24] to [10]
CROSSOVER
POSITION
[OFF], [FRONT LEFT] (front
seat left), [FRONT RIGHT]
(front seat right), [FRONT]
(front seats), [ALL]
TIME ALGNMNT
[INITIAL], [OFF], [CUSTOM]
Select a type of speaker and
adjust the speaker distance
for further customizing in
[CUSTOM].
Types of speaker: [FRONT L],
[FRONT R], [REAR L], [REAR R],
[SUBWOOFER]
Speaker distance (inch):
[140] to [0]
Description
Select a speaker unit (filter) and adjust the
output level.
• Each value you have adjusted changes
when you change the [POSITION] setting
(page 19).
Select a speaker unit (filter) to adjust the
HPF or LPF cut-off frequency and the slope
for each speaker unit.
For details on the [CROSSOVER] setting, see
page 17.
Select a listening position to adjust the
speakers' output levels automatically and
add a delay time that corresponds to the
number and locations of occupied seats.
Select or customize the time alignment
settings to reflect the distance between the
listener's position and each speaker.
• Select [INITIAL] to initialize the setting
value.
• Select [OFF] to reset all setting values to
0.
• The [CUSTOM] setting is available when
[FRONT LEFT] or [FRONT RIGHT] is
selected in [POSITION] (page 19).
• The [CUSTOM] setting is not available
when [OFF] is selected in [SUBWOOFER]
(page 19).
19
En